ProSound BP2K Power Amplifier - 2000W
£279.99
£233.33 excl. VATCheck your postcode
Enter a valid postcode.
credit account (subject to approval).
ProSound BP2K Power Amplifier - 2000W
About this product
The ProSound BP2K Power Amplifier is a compact 1u PA Power Amplifier. It includes a number of features to give the best performance for touring and installation. The amplifier runs quietly and coolly in a rack. Critically silent when in use loaded or unloaded.
The musicality of this amplifier beats most HiFi power amplifiers and monoblocks. Smooth, stable and very sophisticated.
Features
2 x 1000 Watts RMS into 4 Ohms
2 x 600 Watts RMS into 8 Ohms
1 x 1200Watts RMS into 8 Ohm Bridged
Intelligent fans switch in and out dependent on the heat generation automatically to ensure cool running
Limiters protect the BP2K from damage by moving to protect mode when THD is more than 0.5%
Each of the 2 channels has an independent clip, protection and signal indication.
Strong 1u rack ears for easy touring rack installation
2 x XLR balanced Neutrik analogue audio inputs
2 x NL4 Neutrik speakON output connectors
Built-in Protection Includes:
Soft Start
DC
Short Circuit
Overload
Distortion limiting
Overheating
VHF
Indication LEDs on the front panel for Power (blue) Signal (green) and Clip (red)
Always use a power conditioner with this product for your safety and to ensure your expensive PA is protected.
1U amplifiers must be kept cool! High-speed fans are built-in but the only source of airflow is from the front vents so it is of the utmost importance to check monthly and keep these clean and free from clogging up with dust and dirt. Amplifiers will not be repaired under warranty if they fail due to overheating caused by poor maintenance and dust/dirt blocking the cooling vents.